TTB 9-2320-360-14
d. While vehicle is In storage, perform the
b. While vehicle is in storage, perform the
following teaks yearly:
following teaks monthly:
(1) Clean the exterior, interior of cab,
(1) Conduct visual inspection of the vehicle.
engine, and undercarriage. Wash any oil and grease
Check lubricant, battery electrolyte, coolant levels,
from tires.
and tire pressures. Correct any discrepancies.
(2) Conduct a visual inspection of the
(2) Inspect oil can points. Lubricate if
vehicle. Check lubricant levels and tire pressures.
necessary.
correct any discrepancies.
(3) Shift transfer case to neutral, start
(3) Lubricate the chassis, ancillary
engine, and idle for 10 minutes. After 10 minutes of
equipment, winch cables, fifth wheel, and oil can
engine idle, operate engine for 5 minutes at 1500 rpm
points.
or until the engine water temperature reaches 180F.
Shift the transmission slowly through all gear selector
(4) Check the coolant level. Test the coolant
positions. Return the transmission to neutral and the
to ensure that the cooling system is protected against
transfer case to high range.
corrosion and temperatures down to -30F. Add
antifreeze or corrosion inhibitors compatible with
(4) Move vehicle 30 feet forward and
ethylene glycol base antifreeze if cooling system is not
reverse.
adequately protected.
(5) Idle engine 10 minutes before shutdown.
(5) Shift transfer case to neutral, start
c. While vehicle is in storage, perform the
engine, and idle for 10 minutes. After 10 minutes of
following tasks quarterly:
engine idle, operate engine for 5 minutes at 1500 rpm
(1) Conduct a visual inspection of the
or until the engine water temperature reaches 180F.
Shift the transmission slowly through all gear selector
vehicle. Check lubricant, battery electrolyte, coolant
positions. Return the transmission to neutral and the
levels, and tire pressures. Correct any discrepancies.
transfer case to high range.
(2) Shift transfer case to neutral, start
(6) Drive vehicle at least 1/4 mile. While
engine, and idle for 10 minutes. After 10 minutes of
driving, shift transmission through all gear ranges.
engine idle, operate engine for 5 minutes at 1500 rpm
or until the engine water temperature reaches 180F.
(7) Exercise all ancillary equipment and
Shift the transmission slowly through all gear selector
winches. While operating winches, lubricate winch
positions. Return the transmission to neutral and the
cables.
transfer case to high range.
(8) Idle engine 10 minutes before shutdown.
(3) Drive vehicle at least 1/4 mile. While
(9) Change engine oil and oil and fuel filters.
driving, shift transmission through all gear ranges.
(4) Exercise all ancillary equipment and
e. When removing vehicle from storage,
perform the following tasks:
winches. While operating winches, lubricate winch
cables.
(1) Conduct a visual inspection of the
vehicle. Check lubricant levels and tire pressures.
(5) Idle engine 10 minutes before shutdown.
Correct any discrepancies.
(6) Check grease coating on all chromium
(2) Lubricate the chassis, ancillary
plated and unpainted surfaces. If grease was wiped
from chromium plates and unpainted surfaces when
equipment, and oil can points.
vehicle was moved, recoat these surfaces.
9