TB 5-6115-585-23-1
D - Depot
16. Describe deficiencies or symptoms on
the basis of complete checkout and diagnostic
procedure in Equipment TM.
L - Special Repair Activity
a. Enter brief but specific description
Enter the Utili-
8.
Utilization Code.
of failure as a result of complete checkout and
zation Code that applies to this end item and
diagnosis.
your unit. See Appendix C, Table C-1.
b.
Include such factors as weather
9. MCSR ITEM. Print the word "YES"
conditions and type of operations. Give your
or the letter "Y" if the item is reported under
If more room is
opinion of why it failed.
AR 700-138 or SAMS.
This also applies to
needed, use DA Form 2407-1.
components and subsystems of an item or
system reported.
Not mission capable time
must be counted if the warranty fail is also an
c. When the warranty technical bulletin
NMC fault. Otherwise, leave blank.
provides instructions to ship the failed war-
ranted item to another location, the WARCO
will enter the "shipped to" DODAAC.
9a.
ERC.
Leave blank unless needed
locally.
16a.
Remarks.
Pacing
Leave blank unless
9b .
Item.
needed locally.
Enter the warranty start date of
a.
the component lend item. That date will be on
the warranty decal on the item or on the DA
10. Hours. Enter the hour reading from
Form 2408-9 on the item.
the hourmeter mounted on the equipment in
block 3. Round to the nearest hour. If the
equipment has no hourmeter, leave blank.
b.
The WARCO will enter his or her
name, complete telephone number (AUTOVON
or commercial with area code) and UIC.
11. Miles. Enter the miles or kilometers
on the odometer on the equipment in block 3.
Put
Round to the nearest mile or kilometer.
the letter "M" before the number for miles.
SECTION II - WORK ACCOMPLISHED
Put the letter "K" before the number for
kilometers. If the equipment has no odometer,
leave blank.
17a. Repair Organization/ Activity. Enter
the name of the activity/vendor/contractor or
representative providing the repair.
12. Rounds.
Enter the total equivalent
full charge (EFC) rounds fired (from the
If rounds do not
item's DA Form 2408-4).
17b. Location. Enter the location of the
apply, leave blank.
activity in block 17a.
13.
Starts.
Leave blank.
17C. Unit Ident Code. Enter the UIC of
For commercial
the activity in block 17a.
contractors or manufacturers, put the letter
Failure Detected During. Mark the
14.
"K" before FSCM. If not known, leave blank.
box that best describes when the failure was
found.
18. Type of Organization/ Activity Accom-
plishing Work.
Put a check or "X" in the
Mark
15.
First Indication of Trouble.
block that applies to the activity providing the
the box that best described the conditions
repair.
Enter a
when you first found the trouble.
code. See Appendix C, Table C-2.
7
