TB 9-2300-295-15
17
(2)
DA Form 2407 is forwarded by the unit authorized to replace the item when direct exchange of the item
is not involved.
(3)
Evacuating units forward DA Form 2407 when all work is performed by AM General.
b.
Forwarding DA Form 2407. When DA Form 2407 is prepared. after work is accomplished. make sure Copies 2
and 5 are marked "FOR INFORMATION ONLY" and forwarded to
Commander
US Army Tank Automotive
Materiel Readiness Command
ATTN: DRSTA-MTC
Warren, Michigan 48090
Warranty Disputer. When DA Form 2407 is prepared for warranty disputes, make sure Copies 2 and 5 are
c.
marked "WARRANTY DISPUTE" for forwarding to the address given in Paragraph 2 for technical review and evaluation to
minimize techinal misunderstandings between you and AM General whenever possible. You must include the following
information:
-
Name, address, and telephone number of the AM General representative/dealership that refused the service;
-
Specific reason(s) for the refusal: and
-
Specific facts/evidence that you feel will refute AM General's reason(s) for refusal. Include photographs and
sketches, if possible.
Completing DA Form 2407. TM 38-750 governs the preparation of DA Form 2407. The following Information
d.
will assist you in filling out the form for the purpose of claims under the M915 Series vehicle warranty. Refer to Figure 1
for an example of completed DA Form 2407.
(1)
Section I. (To be filled in by originating organization.)
(a)
Heading. Put a "W" in the EIR space. and write in the organization's issue priority
designation code.
(b)
Block la. Enter name of organization submitting the request.
Block 1b. Enter location of unit making the request. Overseas units must enter their APO.
(c)
(d)
Block lc. Enter unit Identification code of the originating organization.
(e)
Block 2. Enter the AM General Corporation serial number found on the Vehicle ldentification Data
Plate or the Serial Number Plate. The ldentification Plate is located on the lower left corner inside the left cab door. The
Number Plate is located on the left side of the truck's frame to the rear of the driver's seat.
(f)
Block 3. Enter the name of the end item.
(g)
Block 4. Leave blank.
(h)
Block 5. Enter vehicle model designation for the defective part found on the Vehicle ldentifation
Data Plate.
(i)
Block 6. Enter national stock number of the vehicle.
Block 7. Enter symbol of the military maintenance activity doing the work.
(j)
(k)
Block 8. Enter appropriate utilization code from Table 1.
Block 9. If defective part(s) can be reported on DA Form 2406, Materiel Readiness Report, place
(l)
an "R" to the right of the "No" block.
(m) Block 10. Leave blank.
(n) Block 11. Enter mileage reading (rounded to the nearest mile) from the odometer at the time of
failure.
7
