maintenance activity doing the work
Block 6. Enter the National Stock Number
(9)
(11) Block 8. Enter the appropriate utilization
(NSN 2320-01-025-3733) of the vehicle.
(10) Block 7. Enter the symbol of the military
Table 1. Utilization Codes
Description
Code
Active Army (except as otherwise listed)
ON
Depot stock
1
Post supply activities, class I installations
2
Post supply activities, class II installations
3
Operational readiness float (ORF)
4
Repair and utilities
5
Army Air Defense Command (ARADCOM) units
6
Army National Guard, except equipment pools
7
Army National Guard, equipment pools
8
Army Reserve units, except equipment pools
A
Army Reserve units, equipment pools
B
Army ROTC
D
Forces Command (FORSCOM) (all TOE units assigned direct FORSCOM)
F
Defense Atomic Support Agency
G
Army Security Agency
H
J
US Army Training and Doctrine Command (TRADOC)
K
Depot installation equipment
P
Equipment assigned to service schools training centers
Q
Military Assistance Program (MAP)
R
Overhaul facility, military
S
Overhaul facility, commercial
T
u
Manufacturing facility
x
Repair Cycle Float (RCF)
Y
of Trouble Codes
Table 2. First Indication
(12) Block 9. If the defective part can be re-
ported on DA Form 2406 (Materiel Readiness Re-
port), place an "R" to the right of the "No" block.
Description
Codes
(13) Block 10. Leave blank.
Noisy
008
Inoperative
(14) Block 11. Enter the mileage reading
068
Overheating
258
(rounded to the nearest mile) from the odometer at
Low performance
387
the time of failure.
Out of adjustment
790
(15) Block 12. Leave blank.
Intermittent
360*
(16) Block 13. Leave blank.
432*
Unstable
(17) Block 14. Check the space provided to indi-
680*
Accident (motor vehicle)
077*
cate when the failure was detected.
777*
(18) Block 15. Check the space that most accu-
Midservice life
rately describes the condition at the time of the
099*
Other
first indication of trouble. For "OTHER," check the
*Denotes code numbers not listed in block 15, DA Form 2407. When selecting one of
space provided, and enter the code number
these codes, the appropriate code must be entered in the space designated "OTHER,"
block 15.
(19) Block 16. Enter "Warranty Claim Action"
NOTE
and give a complete description of the failure.
If the work was accomplished by the
(20) Block 23. Enter the authorization signa-
Oshkosh Truck Corporation or its desig-
ture and the julian date in this block. Check your
nated representative, just copy the in-
local SOP.
formation from the invoice; attach it and
b. Section II. (To be filled in by support activity.)
copy 4 of the work order, to this form.
Fill in section II using the steps below:
7