TB 9-2300-358-24
APPENDIX A
GOVERNMENT FORMS
1. PREPARATION OF DA FORM 2407
a. DA Form 2407, or appropriate form containing the following information, must be used to submit
warranty claim actions for defective supplies (Refer to Table 1).
b. Warranty Disputes. If a dispute arises, immediately forward copies 2 and 5 of a prepared DA Form
2407 marked `WARRANTY DISPUTE' for forwarding to the address given below for technical review
and evaluation to minimize misunderstandings between you and the contractor. You must include
the following information:
Specific reason(s) for the refusal; and
q
Specific facts/evidence that you feel will refute the contractors reason(s) for refusal. Include
q
photographs and sketches, if possible.
Commander
U.S. Army Tank-Automotive Command
ATTN: AMSTA-MTB
Warren, Michigan 48090
c. Completing DA Form 2407. DA PAM 738-750 governs the preparation of DA Form 2407. The following
information will assist you in filling out the form for the purpose of claims under the M939A2 Series
vehicle warranty for supplies in Table 1. Refer to Figure A-1 for an example of a completed DA Form
2407.
(1) Heading. Enter an "x" in the space marked "Warranty".
(2) Enter the W/EDSC if the primary system is Material Condition Status Reportable
(3) Enter appropriate priority designator code. The unit Commander or Chief will authenticate, by
a signature, a priority of 01 through 08.
(4) Space is provided for entering the page number and total pages when entries in Section II are
complete.
(5) Block 1a. Enter the name of the organization submitting the report.
(6) Block 1b. Enter the location of the organization initiating the request; units overseas enter
APO only.
(7) Block 1 c. Enter the unit identification code of the unit identified in block 1a.
(8) Block 2.
(a) For commercial design vehicles, enter the USA registration number.
(b) For ammunition, enter the lot number.
A-1
